【Product introduction】
K11 waterproof coating is made of acrylic latex as the main raw material. It is refined with appropriate additives.
【Scope of application】
Waterproof layer for kitchen, bathroom, pool, wall and floor, roof, basement, cement brick wall and tunnel.
【Product Features】
1. The waterproof membrane is extremely strong, resistant to high temperature, aging and weathering.
2. Environmental protection, mildew proof, antibacterial, watertight, easy to dry.
3. Places with high waterproof and moisture-proof requirements in wet areas.
【Basic processing】
1. The base layer should have a clean and sturdy surface structure with porous and rough, no cracks, no oil stains, and no fat; the cracks should be repaired with waterproofing first. The yin and yang corners are smeared into arcs or obtuse angles to prevent cracks;
2. The waterproofing of concrete and cement mortar plastering surface should be fully wetted with water first, but there should be no moisture hanging or dysprosium.
【Precautions】
1. The construction temperature should be +5°C to +35°C
2. Do not mix this product with other materials or other brand products.
3. This product contains cement, which will cause an alkaline reaction in contact with water, so please protect your skin and eyes. In case of contact, please wash with clean water, in case of eye contact, please seek medical attention immediately.
【Construction method】
1. Open the plastic bucket and take out all the inner packaging materials from the bucket, first pour the emulsion into the plastic bucket, and then slowly pour the powder into the corresponding emulsion.
2. Stir with an electric mixer until there are no lumps, let the slurry stand for about 3 minutes and stir for about 30 seconds.
3. Apply at least two coats with a brush or roller in a criss-cross method. The first layer uses a thick coating to make the base layer completely free of voids. When the first layer has cured and developed sufficient strength, the next layer of construction can be carried out. If necessary, a third construction can be carried out. Please use up the prepared slurry within 50 minutes. Please wash the residual waterproofing on the construction tools with water in time. When the waterproofing is cured, it can only be removed by mechanical methods.
